[Fig. 30] shows a similar joint to the above, but in this case the top rail runs through and it is generally spoken of as a "Halved T Joint" ([Fig. 28, 2]). It may be used in nearly all cases where a top or bottom rail runs through an upright. The method of securing the joint is as before. [Fig. 30] shows a sketch of the joint separated.
| Fig. 31.—Oblique Halving with Shoulder. | Fig. 32.—Oblique Halving. |
At [Fig. 31] is shown an "Oblique Halving Joint," where the oblique piece, or strut, does not run through ([Fig. 28, 3]). This type of joint is used for strengthening framings and shelf brackets; an example of the latter is shown at[ Fig. 48]. A strut or rail of this type prevents movement or distortion to a frame diagonally (generally spoken of in the trade as "racking"). [Fig. 31] shows the joint apart.
[Fig. 32] is an example of Oblique Halving with the upper piece running through ([Fig. 28, 4]). This joint is used in similar positions to [Fig. 31], and has in some cases the disadvantage of showing end grain at the top of the frame. The sketch shows the two pieces separated.
[Fig. 33] is "Dovetail Halving," the dovetail running through the top piece ([Fig. 28, 5]). This is a strong joint, used where outside strain is likely to occur in the top piece, the dovetail preventing the rail from being drawn away from the shoulder. The two pieces are shown separate.
| Fig. 33.—Dovetail Halving. | Fig. 34.—Mitre Halving. |
At [Fig. 34] is seen "Mitred Halving," a somewhat weak joint, but necessary in mirror frames, etc., where good appearance is required on the face side ([Fig. 28, 6]). Its use is obvious if the face of the frame be moulded with beads or other sections which require to intersect one with the other. This also applies if the frame be moulded on its face edges.
[Fig. 35] is a halved joint with one side of the piece dovetailed ([Fig. 28, 8]). This joint is used in similar positions to [Fig. 33], and rather less labour is required in the making. The two pieces are shown separate for clearness.
[Fig. 36] indicates the "Halved Joint," the pieces at one end showing a double dovetail ([Fig. 28, 7]). This particular joint is seldom used except for Manual Training purposes. The illustration shows a sketch of the joint apart.
[Fig. 37] is "Oblique Dovetail Halving," one side of the piece being dovetailed. The joint is used to prevent "racking," and as a cross brace to framing. It is occasionally made with both its sides dovetailed as shown at [Fig. 33]. (For reference, see [Fig. 28, 9]).