The carton is plainly marked so as to indicate which is the outlet burner end of the unit which is also the end where the return and flue are located. Clearance should be provided in both the front and rear of the unit for cleaning. Where possible it is good practice to locate the unit so its sides are parallel to the chimney flue. In all instances locate unit as near chimney flue as possible in order to avoid use of a long flue pipe.

REMOVING CARTON

Once the packaged unit is in its proper place, cut all around the carton on the scored line as shown on carton. The entire carton may then be lifted from the skids.

If it is found necessary to move the unit a little more to place it in the exact location ready for piping, do so before removing skids.

DO NOT PUSH AGAINST ANY PART OF JACKET OR OIL BURNER WHEN MOVING UNIT. TO MOVE UNIT, PUSH AGAINST SKIDS, FLUE BOX OR SMOKE BOX. PUSHING AGAINST JACKET WILL RESULT IN DAMAGE.

REMOVING SKIDS

The skids are specially designed for easy removal. It is necessary, however, to follow these instructions carefully.

  1. After unit is in proper place, remove the two cross pieces from skids by pulling out all scaffolding (double headed) nails.
  2. By inserting pinch bar or 2" × 4" underneath the smoke box (rear of unit), tilt one side of unit just high enough to lift lugs out of holes in skid, then knock skid out from underneath unit. Then do the same thing on the other side of unit. THE UNIT IS NOT BOLTED TO THE SKIDS. The 3/4" lugs welded to the unit simply fit into the 3/4" holes in the skids.

IMPORTANT
DO NOT TILT UNIT BY PUSHING AGAINST JACKET
IT IS NOT NECESSARY
AND BY DOING SO THE JACKET WILL BE DAMAGED

LEVELING UNIT