German Gas Coffee-Roasting Plant Equipped with Ideal-Rapid Machines
To roast coffee by coal or coke usually requires from twenty-five to thirty minutes, depending on the moisture-content of the beans; whether they are spongy or flinty; whether a light, medium, or dark roast is desired; and on the skill of the operator. Gas roasting requires from fifteen to twenty minutes. The quicker the roast, the better the coffee, is the opinion of many trade leaders, one of whom[325] says:
It is a growing belief that in roasts of short duration the largest percentage of the aromatic properties is retained. A slow roast has the effect of baking and does not give full development; also, slow roasts seldom produce bright roasts, and they usually make the coffee hard instead of brittle, even when the color standard has been attained.
French Gas Coffee-Roasting Plant Equipped with Moderne Machines
While coffees of widely varying degrees of moisture require somewhat different treatment, the consensus of opinion is that the best results are obtained from a slow fire at the beginning, until some of the moisture has been driven off, when the stronger application of heat may be given for development. An intense heat in the beginning often results in "tipping", or charring, the little germ at the end, the most sensitive part of the bean.
Scorched beans have been caught at some point in the cylinder, often in a bent flange. Burning on one face, sometimes called "kissing the cheeks", is caused by the too rapid revolution of the cylinder, so that some of the coffee "carries over". In the best practise, crowding of cylinders is avoided; many roasters making it a rule not to exceed ninety percent of the rated capacity of the cylinder.
Those operating gas roasters may effect a fuel economy by running a low grade coffee in the cylinder after the last roast has been drawn and the gas extinguished; five minutes' revolution absorbs the heat and drives off a proportion of moisture. The coffee, which may then be left in the cylinder, requires less time and fuel in the morning, and the roast is finished while the cylinder is warming up. Double roasting brightens a roast, but is a detriment to the cup quality. A dull roasting coffee may be improved by revolving the green coffee in a cylinder without heat for twenty minutes, which has the effect of milling.
The use of a small amount of water upon roasts gives better control by checking the roast at the proper point—the crucial time of its greatest heat; also, it swells and brightens the coffee, and tends to close the outer pores. While the addition of water is open to abuse, few roasters have soaked their coffees enough to offset the natural shrinkage as much as three or four percent. Such practise would result greatly to the detriment of the cup quality.